1969 Camaro project X11 4 speed old bracket drag race car Clear Title Roller

1969 Chevrolet Camaro

1969 Camaro project car.
This car has a clear NC title that matches the VIN plate on the dash and the stamped partial vin on the firewall.
Please check out the link below for more pictures:
Photos Here
It is an old bracket race car that according to the decals looks like it was raced from the mid 90s-99 or 2000.
It has no engine, transmission, radiator or wiring. The only original glass with the car is the back window. The windshield and side glasses are all lexan from where it was a race car. There are no regulators or anything in the doors. I do have the latch mechanisms in a box.
The rear package tray and seat support brace were cut out and removed along with the panel below the rear quarter glasses on each side. There was a "rear seat delete" fabbed up for the car and is included.
The car comes with the fiberglass racing seat, pro-matic ii shifter and chrome bolt in roll bar. I do not have the bolts or plates for installing the bar. Should be easy enough to make if you want to reinstall.
The car does have rust as shown in the pictures, but is solid where it needs to be.
The whole interior, firewall, underside, and problem areas of the exterior have been blasted along with the front subframe, frame connectors and rear end housing.
The rockers are very nice other than the passenger side having some pin holes about midway. The drivers side floors have some holes but not flintstone like. The passenger front and rear pan were cut out. There is rust in the channel around the back glass, but the rest of the roof skin is very nice. The trunk lid is near perfect from what I can tell. The trunk gutter is also solid and has been blasted. Hood was cut for the hood scoop. Doors have small rust spots in the bottom corners of the outer skin. Easy fix. Fenders are about the same. Quarters need work like usual.
I have used 1967 Camaro deluxe interior to go with the car. Bucket seats, narrow rear seat, door panels, sun visors, etc. They are old and used but the seat frames would definitely be usable. Driveshaft is also included. Rearend appears to be a posi, but not sure what gear is in it.
The cragar wheels would probably clean up decent. Tires are old.
The trim tag on the cowl was blaster along with the firewall and is hard to make out. It is an x11. Nothing special about it. Not an original RS, just had a RS grill in it.
Any other questions please ask and I will answer you the best I can or get you pictures of what you'd like to see.